Author Topic: help! BASIC PEDAL SET-UP>>> (Read 24376 times)

MelMe1 · « **Reply #50 on:** March 15, 2008, 08:21:10 PM »

18mA lang nga pala ang boston engineering. Nasa manual current draw: 18mA DC9v. Diba ang laman ng power supply ay katulad lang ng adapter?tama ba?

shodawmoon · « **Reply #51 on:** June 21, 2008, 11:34:29 PM »

si ser Emil Murillo of PEDALMAX...san ka sa antipolo pare???

guitbox · « **Reply #52 on:** June 22, 2008, 12:09:20 AM »

Quote from: boogsy on March 15, 2008, 03:26:02 PM

I believe pedals dont have that much current draw. nasa 30-60mA lang ata eh. Im not sure though. A BOSS PSA outs 200mA and it can power 3 pedals.

i agree...

actually, for dirt peds it's just in the 15mA+ area.
for modulation/delay pedals, it can reach up to 60mA.

so a 1A psu should be good enough already.

arkeetar · « **Reply #53 on:** June 22, 2008, 11:52:15 AM »

dapat may allowance ka sa psu, hindi ka sasagad...

and kailangan regulated...

pedalmax! thru air21, dadating s'yo yan, saka ok kausap si emil

greenweenie · « **Reply #54 on:** June 22, 2008, 02:42:42 PM »

Quote from: lowtuneduser on March 01, 2007, 04:03:05 AM

LS-2 or NS-2 pwedeng mag power ng peds pero mag PSM ka na lang kase mas mura.

Lol. Kung naghahanap lang ng pang power na may useful function, TU-2 na.

MelMe1 · « **Reply #55 on:** August 03, 2008, 08:49:48 PM »

Patulong naman mga Sir sa pagarrange ng aking effects.
Ang effects ko ay screaming blues,hyper fuzz at chorus.

Ano ba ang dapat mauna ang Screaming blues o ang hyper fuzz?
Saan ko ikakabit yung patch cable ko sa Screaming blues?Dalawa kasi yung output niya, may output 1 (Amp) Output 2 (Mixer)? Alin po dun sa dalawa?

Natry ko po yung setup na AMP>>>CHORUS>>>HYPER FUZZ>>>OUTPUT 2 (MIXER) SCREAMING BLUES>>>GUITAR

Ang problema ay kapag isabay kung gamitin ang hyper fuzz at screaming blues lalakas yung volume kahit volume 5 sa amp volume 5 sa Screaming blues at Volume 0 sa hyper fuzz. Ang ingay ng resulta at pangit yung tone na lumalabas.

guitbox · « **Reply #56 on:** August 04, 2008, 12:29:58 AM »

kung ako yan, ganito:
gtr>screamin blues>fuzz>chorus

pero dahil manageable ung set-up mo, pwede ka naman mag-experiment kung anong magandang combination dahil wala naman eksaktong rule on how to arrange them.

kung pagsasabayin mo naman dirt peds mo, i suggest gawin mong booster ung blues---meaning set mo sa 0 ung gain at max ang volume nya. however, i haven't tried any of the mentioned (dirt) pedals so i'm just making a calculated guess on how you can do it.

lastly, for w/c output jack to use---use 'output 1'. yung 'output 2' e kung ala kang amp., pwede un gamitin derecho sa mixer.

manilacoke3 · « **Reply #57 on:** August 04, 2008, 02:27:40 AM »

if you say you're into Satriani's, then DS1 + Wah would be the basic.

greenweenie · « **Reply #58 on:** August 04, 2008, 10:18:04 AM »

Quote from: manilacoke3 on August 04, 2008, 02:27:40 AM

if you say you're into Satriani's, then DS1 + Wah would be the basic.

Baliktad si Satriani. Wah > DS1. I prefer the opposite.

the_Nong · « **Reply #59 on:** August 15, 2008, 05:34:35 PM »

basic set-up update:

wah > BOSS FZ-5 > BOSS BD-2 > MXR Micro Amp

diaboliche · « **Reply #60 on:** September 09, 2008, 07:02:05 PM »

Mga sir paano po ba e set up ang zoom g1 at modded ds100?

maxi_musikero · « **Reply #61 on:** September 15, 2008, 09:45:59 AM »

question for the experts:

if i have a preamp/DI and a reverb unit, what will be my best arrangement for the best tone:

a) acoustic guitar - reverb unit - preamp/DI - mixer

b) acoustic guitar - preamp/DI - reverb unit - mixer

the reverb unit is like your normal multi-effects unit. meaning the input and the output are both 1/4 PL unbalanced. the preamp/DI has a balanced out.

EDIT: i had to post this here because i'm not getting answers on the original thread i posted this in. hopefully i will get answers here. thanks!

cumbersome · « **Reply #62 on:** September 15, 2008, 11:40:06 AM »

^I'd recommend this- acoustic>reverb>DI/preamp. If you put the reverb last on the chain, you'll end up with an unbalanced signal. It might be better to just use the mixer reverb though and take the reverb effect out of the chain. Just a suggestion.

maxi_musikero · « **Reply #63 on:** September 15, 2008, 11:53:58 AM »

Quote from: cumbersome on September 15, 2008, 11:40:06 AM

^I'd recommend this- acoustic>reverb>DI/preamp. If you put the reverb last on the chain, you'll end up with an unbalanced signal. It might be better to just use the mixer reverb though and take the reverb effect out of the chain. Just a suggestion.

this the setup that i had in mind also...but a friend told me to put the preamp/DI first before the reverb. what's the difference?

mixer reverbs have limited capability. i want to be more flexible in my reverb tone as much as possible.

cumbersome · « **Reply #64 on:** September 15, 2008, 02:11:45 PM »

^The preamp-then-reverb arrangement is the recommended order of effects because it better simulates an amp in a room or a hall (sound comes out of the amp, bounces in the room thus creating reverb). But in your case, i would think that it's more important to have a balanced signal than following such recommendation. Better yet, get a reverb with balanced I/O, in which case you can put it after the preamp. Or a preamp with built-in reverb.

maxi_musikero · « **Reply #65 on:** September 16, 2008, 02:25:59 PM »

Quote from: cumbersome on September 15, 2008, 02:11:45 PM

^The preamp-then-reverb arrangement is the recommended order of effects because it better simulates an amp in a room or a hall (sound comes out of the amp, bounces in the room thus creating reverb). But in your case, i would think that it's more important to have a balanced signal than following such recommendation. Better yet, get a reverb with balanced I/O, in which case you can put it after the preamp. Or a preamp with built-in reverb.

ano bang possible impact pag hindi ko nasunod yung recommended setup? will the controls in the preamp/DI and the reverb unit still work? distinguishable parin yung change in tone pag nag-tweak?

MelMe1 · « **Reply #66 on:** September 16, 2008, 11:13:46 PM »

Ano ba masmagandang pakinggan at dapat? Ano ang dapat mauna distortion or overdrive?
Mauna ang Turbo Distortion then Blues driver or Blues driver tapos turbo distortion? Any suggestions?

tnx! really need help.

the_Nong · « **Reply #67 on:** September 16, 2008, 11:45:38 PM »

Quote from: MelMe1 on September 16, 2008, 11:13:46 PM

Ano ba masmagandang pakinggan at dapat? Ano ang dapat mauna distortion or overdrive?
Mauna ang Turbo Distortion then Blues driver or Blues driver tapos turbo distortion? Any suggestions? tnx! really need help.

depends sa taste o sa sound na gusto mo. i never used both dirt and dist pedals at the same time.

i doesnt matter kung anu mauna sa set up.. what sound are you looking for / you want?

MelMe1 · « **Reply #68 on:** September 17, 2008, 09:29:58 AM »

Hindi ko kasi madistinguish ang pinagkaiba eh pero normally ano ba dapat?

guitbox · « **Reply #69 on:** September 17, 2008, 09:45:49 AM »

it really depends sa application mo.

natutunan ko rin to dito and thru experience...

if you use them individually, it wouldn't matter w/c one goes first.
but if you cascade them, you have 2 scenarios:
1) whatever you put first in the chain (from guitar), adds gain to the
second--->gain boosting
2) whatever you put after, adds volume and "color"--->volume boosting

on #2, volume is achieved when your setting is: 0 gain, max level (on the 2nd pedal). "color" meaning the sound is a combo of the 2 pedals.

hope this helps.

MelMe1 · « **Reply #70 on:** September 17, 2008, 10:14:57 AM »

So masmaganda pala kapag mauna ang ds2 kesa sa bd2.
Pero kung kayo ang ipapasetup nito ano ang uunahin niyo?

guitbox · « **Reply #71 on:** September 17, 2008, 12:33:21 PM »

Quote from: MelMe1 on September 17, 2008, 10:14:57 AM

So masmaganda pala kapag mauna ang ds2 kesa sa bd2.
Pero kung kayo ang ipapasetup nito ano ang uunahin niyo?

"masmaganda" can only be determined by yourself---what works for your ears and/or application. but if i were to set this up it would be:

gtr > ds2 > bd2

reason:
given the 2 pedal setup, i intend to boost the ds2 for solos.

nez · « **Reply #72 on:** October 02, 2008, 10:06:23 AM »

Getting joe satriani sound
1.your pick-ups Humbuckers rewound medium output
2.marshall amp or peavey if marshall set FX to chorus delay.
3.DS-1 Brit mod,Digital delay.for the warm sound
MXR doubleshot dist.and morley power Wah for psched out sound

hehe
^_^ just a little help..

locoto · « **Reply #73 on:** October 03, 2008, 11:23:45 AM »

mga sir patulong paano po ang magandang set-up ng mga pedals ko? hndi ko alam ang tamang pgkakasunod-sunod eto pedals ko=dd6,ts7 tubescreamer,phase90,ge7,sd1

Kclan · « **Reply #74 on:** October 03, 2008, 01:40:25 PM »

you want JSatch's sound? here it is:

http://www.satriani.com/gear/

simple yet rock!!!

News:

Author Topic: help! BASIC PEDAL SET-UP>>> (Read 24376 times)

nez

locoto