Direct connection to P.A. LoudSpeaker via a Guitar Amp

[Asurada666]

good day mga sir, tatanong ko lang kung wala bang magiging problema sa LoudSpeaker kung gagawing direct additional speaker ng isang guitar amp tulad ng example below.

Guitar -> Guitar Effects -> ZT Lunchbox amp -> (12" or 15" 300 or 500watts) P.A. LoudSpeaker (Active or Pasive)

ZT Amp Specifications:
Dimensions (H x W x D): 6.5 x 7.75 x 5.5 inches/165mm x 197mm x 140mm
Weight: 5 lbs./2.3kg
Total Output Power: 35 watts RMS/80 watts Peak
Peak Output: >117dB at 1 meter
Speaker: 5 inch/130mm
Voltage: 115V/230V Selectable
Controls: Gain, Tone, Volume, Line Out/Headphone Level, Speaker On/Off

any idea or suggestion will be a big help.

Thank you in Advance ! ! ! !

[Asurada666]

Any Idea mga sir?

[grasyaps]

Ilang ohms ang sasaksakan mong speaker? Min of 8 ohms daw eh

[skin]

Mic mo na lang amp mo.

[Asurada666]

Ilang ohms ang sasaksakan mong speaker? Min of 8 ohms daw eh

sorry sir di ako familiar sa mga ohms ng speakers, alam ko lang sir is watts.

Mic mo na lang amp mo.

pwede rin sir pada anin ko sa mic, pero mas ok prefered ko ung tunog galing likod ko.


salamat sa mga reply mga sir.

nag post din ako sa GC about this matter. they tell me na bad idea ung gagawin ko. parang much better na i-mic nalang ung amp ko.

thanks mga sir.

[IncX]

kung isasaksak mo sa PA yung amp mo, be sure na may DI ... or kahit wag ka na dumaan sa amp, kumuha ka nalang ng sansamp tapos DI mo sa PA. di ko pa na try kasi wala akong guitar amp na may DI.

na try ko sa bass amp, ok naman, pero usually clean tone lang naman sa bass, so mas compatible PA at bass

[Tarkuz Toccata]

Yamaha 15" loudspeaker (passive/active)?!?

 

[Asurada666]

Yamaha 15" loudspeaker (passive/active)?!?

 

sorry sir mis-info, what i mean is YAMAHA 15" LoudSpeaker (Pasive or Active) Speaker.

[skin]

pwede rin sir pada anin ko sa mic, pero mas ok prefered ko ung tunog galing likod ko.

I'm sure hindi mo preferred ang tunog pag galing sa output ng amp.  Preferred setup puede pa.

To get a more accurate sound, mic your amp.

[grasyaps]

I'm sure hindi mo preferred ang tunog pag galing sa output ng amp.  Preferred setup puede pa.

To get a more accurate sound, mic your amp.

Depende anong mic at anong position.

And the plot thickens hehehe

TS, mag DI ka nlng.

Guitar >>> DI >>> Split it, Para OUT to the amp, then Balanced OUT sa mixer or active speakers mo. At least, controlled mo ung tunog na nadidinig mo. Bahala na yung sa mgtitimpla sa lanas

[skin]

Depende anong mic at anong position.

And the plot thickens hehehe

TS, mag DI ka nlng.

Guitar >>> DI >>> Split it, Para OUT to the amp, then Balanced OUT sa mixer or active speakers mo. At least, controlled mo ung tunog na nadidinig mo. Bahala na yung sa mgtitimpla sa lanas

Pasok na Shure SM57 sa mga yan.  Baka kasi puro analog ang pedals pangit tunog niyan ng direct.

Puede DI kung may amp simulator ka.

Kuha ka SansAmp.  Hehe.

[inigo]

Controls: Gain, Tone, Volume, Line Out/Headphone Level, Speaker On/Off

Wait, may line/headphone out naman e. I think pwede ito derecho sa powered/active speaker, basta through the line/headphone out. Same lang sya as playing an MP3 player through a powered speaker.

Pwede lang sa passive speaker (as in via re-routing the speaker cable to the passive speaker) kapag matched ang wattages ng amp and speaker. Pero walang masyadong benefit dahil same lang ang power ng amp. Siguro mas magiging clear/round lang ang tunog dahil sa mas malaking speaker, pero loudness will be similar.

[Asurada666]

Naku Maraming salamat sa mga reply. andme pa palang option na pwedeng gawin,,, pero it depends parin sa player. and dun sa suggestion na mag mic in or DI box. medyo di ko sya prefer kasi pano kung small venue lang na biglaang jam, at dala mo lang ung lunchbox at may extra PA speaker. some experiment type lang mga sir.

but salamat parin, keep it going mga sir.

[Tarkuz Toccata]

To get a more accurate sound, mic your amp.

I believe this is the best answer.