hulika

Author Topic: Ibanez guitar users thread  (Read 1926743 times)

Offline LaXter

  • Senior Member
  • ***
Re: Ibanez guitar users thread
« Reply #19675 on: March 28, 2017, 11:01:15 AM »
^ Actually, medyo may grooves na yan. Yung sa low e string, nahulma nga yung winds nung string dun sa pressure pad at medyo may groove na mababaw lang din yung sa G at high e, though hindi naman ganun ka lalalim na kapareho na ng thickness ng string yung grooves.

Nacheck ko pala yung screws sa likod nung nut, medyo maluwang  :eek: kaya hinigpitan ko na, ayun nabawasa ng konti, kaso nagslip talga yung strings sa nut kahit nakalock na.
GAS-Masked

Offline knet370

  • Senior Member
  • ***
Re: Ibanez guitar users thread
« Reply #19676 on: March 28, 2017, 12:43:47 PM »
I think masyado ko nga ata nahigpitan, kasi may tiny, shallow scratches na yung pads na kita sa pics below. How tight is tight enough nga ba?





ang ginagawa ko, i tighten the screw upto a point na hindi ko na maikot yung allen wrench. tapos may last quarter turn lang akong mejo may effort na pag ikot. just to really know na its tight enough.
yung mga very small grooves sa pressure pads normal lang yung. yung pads ng edge pro if original is hard enough. taon bago mo pa pudpod. base dun sa pag kwento mo, i think baka hindi na sa nut yung problem mo. if nag out of tune sya kahit mag pluck kalang, siguro nasa tension mo na or sa tremolo mo mismo. check mo kung yung knife edges ng trem mo. plus edge pro are notorious about its bridge post turning. kaya may mod na stud lock about sa edge pro. pero kung dati wala namang ganitong problem at recently lang after restring, big factor is the tension plus the trem knife edge.

Offline knet370

  • Senior Member
  • ***
Re: Ibanez guitar users thread
« Reply #19677 on: March 28, 2017, 12:53:03 PM »
just recently changed the bridge pickup from sd duncan distortion to bkp warpig chrome cover with black hexbolts.



Offline anjoesatriani

  • Veteran Member
  • ****
Re: Ibanez guitar users thread
« Reply #19678 on: April 05, 2017, 06:25:30 PM »
just recently changed the bridge pickup from sd duncan distortion to bkp warpig chrome cover with black hexbolts.

and how was the tonal response of your warpig to your taste compared from your previous sd distortion?  :?

Offline Zacchary_amadeus

  • Forum Fanatic
  • ****
Re: Ibanez guitar users thread
« Reply #19679 on: April 10, 2017, 07:33:59 PM »
my new guitar bought from ebay, pwede po kayang palitan yung floyd rose trem niya ng floyd rose na may lock yung trem bar?? I mean hindi yung pang gio yung pang rg ibanez din?? Thanks


\"Why worry if you can pray\"


Online Boxedking

  • Philmusicus Addictus
  • *****
Re: Ibanez guitar users thread
« Reply #19680 on: April 10, 2017, 07:53:07 PM »
my new guitar bought from ebay, pwede po kayang palitan yung floyd rose trem niya ng floyd rose na may lock yung trem bar?? I mean hindi yung pang gio yung pang rg ibanez din?? Thanks


That is an Ibanez Edge 3 trem. Floyd Rose is a brand. Double-locking floating trem is the correct way to call it.

Based on previous posts in this thread, yes you may replace your Edge 3 trem with a Floyd Rose trem but you have to do some minor rerouting on the cavity for it to fit. Some replaced theirs with a Gotoh trem.
www.soundclick.com/viruprison | www.soundcloud.com/lei-guitarist

Don't let the gearhead kill the musician in you. Philmusic s/b PhilGEAR

Offline Zacchary_amadeus

  • Forum Fanatic
  • ****
Re: Ibanez guitar users thread
« Reply #19681 on: April 10, 2017, 07:57:07 PM »
That is an Ibanez Edge 3 trem. Floyd Rose is a brand. Double-locking floating trem is the correct way to call it.

Based on previous posts in this thread, yes you may replace your Edge 3 trem with a Floyd Rose trem but you have to do some minor rerouting on the cavity for it to fit. Some replaced theirs with a Gotoh trem.

How about ibanez double locking trem?? Can it replace?? Where in the world can i find such trem?? Thanks
\"Why worry if you can pray\"

Offline mbsunga

  • Philmusicus Addictus
  • *****
Re: Ibanez guitar users thread
« Reply #19682 on: April 10, 2017, 10:22:00 PM »
Guys ask ko lang if yung old ibanez korean plant na world plant is the same as the world music instrument ng korea na gumagawa ng prs at chapman

TiA

Offline Van*

  • Philmusicus Addictus
  • *****
Re: Ibanez guitar users thread
« Reply #19683 on: April 11, 2017, 11:38:48 PM »
How about ibanez double locking trem?? Can it replace?? Where in the world can i find such trem?? Thanks
You mean ILT trems?
What you own, owns you.

Offline ericbaquiran

  • Forum Fanatic
  • ****
Re: Ibanez guitar users thread
« Reply #19684 on: April 13, 2017, 08:01:11 PM »
Guys ask ko lang if yung old ibanez korean plant na world plant is the same as the world music instrument ng korea na gumagawa ng prs at chapman

TiA

Yes.

Offline Zacchary_amadeus

  • Forum Fanatic
  • ****
Re: Ibanez guitar users thread
« Reply #19685 on: April 14, 2017, 03:55:25 PM »
You mean ILT trems?

No sir, im talking about the prestige trems😬😬😬
\"Why worry if you can pray\"

Online cayle

  • Philmusicus Addictus
  • *****
Re: Ibanez guitar users thread
« Reply #19686 on: April 14, 2017, 03:59:50 PM »
No sir, im talking about the prestige trems😬😬😬

www.ibanezrules.com

Offline powghi

  • Veteran Member
  • ****
Re: Ibanez guitar users thread
« Reply #19687 on: April 15, 2017, 10:18:56 AM »


rgd2120z-ish


Sent from my iPhone using Tapatalk

Offline knet370

  • Senior Member
  • ***
Re: Ibanez guitar users thread
« Reply #19688 on: April 18, 2017, 02:55:11 PM »
and how was the tonal response of your warpig to your taste compared from your previous sd distortion?  :?

in a nutshell, on standard tuning the two seems to have a similar voicing. but on drop C# which is the guitar is tuned to, the bkp have more clarity. i like the mids better. strings ring out much better on heavy distorted chords. thats on a swamp ash body. ymmv.

Offline knet370

  • Senior Member
  • ***
Re: Ibanez guitar users thread
« Reply #19689 on: April 18, 2017, 03:15:13 PM »
pickup swaps again

before: bkp warpig chrome covers black hex bolts
after: bkp aftermath black covers with SS hex bolts


my thoughts: on heavy distorted chugs, the mids and highs sounds a bit "nasal". like a dmz titan i have. im not sure if i like it. the cleans are glassy though which i like. might put it on a basswood and revert back to warpigs.
« Last Edit: April 18, 2017, 04:19:11 PM by knet370 »

Online max28

  • Forum Fanatic
  • ****
Re: Ibanez guitar users thread
« Reply #19690 on: April 25, 2017, 07:12:17 PM »
anyone knows kung ano mga available 7's sa AP ngayon?
« Last Edit: April 27, 2017, 07:08:12 PM by max28 »

Offline Screamous

  • Veteran Member
  • ****
Re: Ibanez guitar users thread
« Reply #19691 on: May 09, 2017, 04:36:00 PM »
I currently own an Ibanez RG1570 bought it from Mr. Freak.

Question:
what do i need to do to remove the rust from the Bridge?

do you guys (who've done it) detach the bridge and soak it in WD40?  :eek:
Masters are once an apprentice

Offline Drac

  • Regular Member
  • ***
Re: Ibanez guitar users thread
« Reply #19692 on: May 10, 2017, 07:54:47 PM »
I currently own an Ibanez RG1570 bought it from Mr. Freak.

Question:
what do i need to do to remove the rust from the Bridge?

do you guys (who've done it) detach the bridge and soak it in WD40?  :eek:

Never tried anything like WD40,  baka masyado corrosive. Madali lang talaga matangal yung coating sa mga Edge Pro, 
Take me as I am!!

Online spoonbender

  • Forum Fanatic
  • ****
Re: Ibanez guitar users thread
« Reply #19693 on: May 15, 2017, 08:02:47 PM »
Since I can't source Ibanez SureGrips (bottom) for my other trem arms, i decided to create my own.
Bought a shrink tube from the local electronics store for 38/meter and fitted 2 layers on the trem arms.
Works perfectly.



Online spoonbender

  • Forum Fanatic
  • ****
Re: Ibanez guitar users thread
« Reply #19694 on: May 15, 2017, 08:06:40 PM »
Never tried anything like WD40,  baka masyado corrosive. Madali lang talaga matangal yung coating sa mga Edge Pro,

Try mo to, 99 lang sa puregold.
Non-abrasive, non-corrosive.


Offline knet370

  • Senior Member
  • ***
Re: Ibanez guitar users thread
« Reply #19695 on: May 15, 2017, 09:35:21 PM »
Since I can't source Ibanez SureGrips (bottom) for my other trem arms, i decided to create my own.
Bought a shrink tube from the local electronics store for 38/meter and fitted 2 layers on the trem arms.
Works perfectly.



Nice hack!

Offline odalisque

  • Philmusicus Addictus
  • *****
Re: Ibanez guitar users thread
« Reply #19696 on: August 05, 2017, 08:29:55 PM »
Got this earlier during the day!

1990 MIJ Ibanez Radius 440R
- DiMarzio Mo' Joe and PAF Joe
- Original Edge Tremolo
- 'Ultra' neck profile









Lastly... poor man's Ibanez JEM and JS of sorts.  :)

1987 Ibanez RG550
- Stainless Steel Jumbo Frets
- DiMarzio Breed and PAF Pro (bridge and neck respectively)

« Last Edit: August 07, 2017, 11:24:21 AM by odalisque »

Offline satch

  • Senior Member
  • ***
Re: Ibanez guitar users thread
« Reply #19697 on: August 29, 2017, 02:56:38 PM »
Hey guys! Got an ibanez RG MIJ for sometime na. Needs a lot of TLC to restore. Any ideas kung saan pwede dalhin? Im located in QC/KatipunAn.


Sent from my iPhone using Tapatalk
Rock Guitarist wannabe

Offline knet370

  • Senior Member
  • ***
Re: Ibanez guitar users thread
« Reply #19698 on: August 29, 2017, 04:49:33 PM »
Hey guys! Got an ibanez RG MIJ for sometime na. Needs a lot of TLC to restore. Any ideas kung saan pwede dalhin? Im located in QC/KatipunAn.


Sent from my iPhone using Tapatalk

try papi's guitar bro
https://www.facebook.com/papisguitar/

Offline satch

  • Senior Member
  • ***
Re: Ibanez guitar users thread
« Reply #19699 on: August 29, 2017, 04:56:30 PM »
try papi's guitar bro
https://www.facebook.com/papisguitar/


Salamat sa input kaptid. But gaya ng sinabi nya, medyo limited services nia. Im looking for something gaya ng services ni guitar hospital.




Sent from my iPhone using Tapatalk
Rock Guitarist wannabe