Guys paturo naman kung papano ikabit ang Double Rails sa strat na naka SSS setup.
I see a Green, Red, White, Black and an Uninsulated wire...
Saan po ikakabit ang bawat wire? Medyo nalilito ako sa wiring ng volume. Newbie here.
Di ko naman madala gitara ko sa TMS kasi napakalayo ng bagay ko.
Thanks in advance...
for those who will install the double rails on their own, here's where the wires go:
Bare and
black - to ground / volume pot base
Green - to the appropriate pickup selector tab/ring
Red and
White - solder together and shield the end with an electrical tape, or solder them to the tab/ring of a push/pull pot or DPDT switch (if you opt for a coil tap)
If you notice some out of phase tone or volume drop when combining it with a neighboring pickup:
1. exchange the positions of the green and black wires of the dual rail
or:
2. exchange the position of the wires of the neighbor pickup (example: in a strat, exchange soldering points of its ground and hot wires)
this also applies to other 4-conductor humbuckers of artec and entwistle (GCH, HDN, Dark Star, GVH, HBBA, HBWA, HBBA117, etc..)
take extra care when stripping the wires. thanks!