Nice input sir, pero paano kung sa live na halimbawa mayroon akong patches na may preamp at mayroong wala. sa CD in AUx parin ba ako sasaksak sa amp? o ililipat ko pa ng saksakan kapag wala ng preamp ang setting ng gt10 ko sa guitar input? just in case walang PA na pwedeng pagsaksakan ang GT-10. kung direct naman sa PA paano ginagawa iyon? anong cable ang gagamitin ko doon?sorry noob questions..
okay sali ako ha, very simple guys. . .
gt-10 connecting in front of an amp: (eto yung isasaksak nyo un left output ng gt-10 sa input ng kahit anong amp
1. as much as possible use the od/ds ng gt-10 nyo to drive your amp, better if you can set your mfx to manual mode to control other fx, od/ds etc. ..
2. you may use the pre amp simulations ng gt-10 but you must bypass or turn off yung mga cab models, stacking na nga ng amp pati cab models factor pa, then get the flat response of your amp(when i say amp, it is your real amp kung saan nyo isasaksak gt-10 nyo) usually nasa 12 o'clock position ang low/mid/hi or todo way up ang mid and todo lowest naman ang low and highs OR connect nyo muna ang guitar nyo sa amp nyo and play some chords and listen to the tonal character ng amp nyo, kapag masyado ma-treble you must cut yung high ng amp. 3o'clock is a good position to start with.
gt-10 connecting to an amp with cd in or send/return loop or a mixer/line
1. it is like connecting to a mixer or power amp, this is the best way to use the amp models of your gt-10, because your amp will act like a straight speaker, bypassed na agad ang tonal character ng amp nyo. the tone of the amp models from your gt-10 na lang ang lalabas. Use the line/out ng gt-10 in this setting.
Guys analog users are just using stomps to drive their amp. and their main reason to hate mfx is because it is not the real thing.pero maganda ang od/ds ng gt-10 mejo sablay nga lang sa amp models. And all analog users are obviously in manual mode ika nga,
lets us explore muna yung od/ds ng gt-10. Metal zone lang busog na ako eh. i tried it before using my mt-2 stomp and the mt-2 model of gt-10, napa wow ako kasi kahit anong tweak ko sa mt2 ko eh kayang habulin ng gt-10 mt2 model. Superb! dyan talaga nakilalala ang boss, sa stomps but amp modelling mejo sablay talaga sila, and i feel sorry for that. Use your amp models when making a recording, or connecting to a mixer etc. Anyway sino ba ang may kailangan sa amp modelling? Usually metal sounds lang naman nangangailangan nun and i can say that gt-10 is not for metal guiarists, believe me.
If your problem is your patch then try to create a patch with a dirt tone driven by your od/ds and a separate patch with dirt tone driven by an amp sims.